JLG G6-42P Features And Specs
JLG G6-42P Features
The JLG G6-42P telehandler combines high performance with durability for job sites demanding power and agility.
JLG G6-42P Specs
| Rated Capacity At 24 in. (610 mm) load center | 6,600 lb (3,000 kg) |
| Maximum Lift Height | 42 ft (12.8 m) |
| Frame Leveling | 8 degrees |
| Capacity at max reach | 1500 kg |
| Lift Speed (boom retracted) | Up 11.8 sec Down 8.9 sec |
| Boom speed (extended/retracted) | Extend: 13.4 sec Retract: 16.5 sec |
| Travel Speeds Forward | 2WD: 16 mph (25.7 kmph) 4WD: 6 mph (9.7 kmph) |
| Drawbar Pull (loaded) | 16,300 lb (7,390 kg) |
| Operating Weight | 23,470 lb (10,646 kg) |
| Length (less forks) | 218 in. (5.53 m) |
| Width | 96 in. (2.43 m) |
| Height | 94 in. (2.38 m) |
| Wheelbase | 130 in. (3.30 m) |
| Ground Clearance | 17.75 in. (450 mm) |
| Outside Turning Radius | 171 in. (4.34 m) |
| Max. Reach from Front Tires to 24 in. (609 mm) Load Center |
29 ft (8.84 m) |
STANDARD EQUIPMENT, OPTIONS & ATTACHMENTS FOR THE JLG G6-42P
Engine
- Make and Model John Deere 4045DF150
- Turbocharged
- Fuel Diesel
- Cycles 4
- No. of Cylinders 4
- Displacement 276 cu in (4.5 L)
- Rated Speed 2,500 rpm
- Max. Gross BHP 99 hp (74 kW)
- Fuel Tank 46 gal (174 L)
Engine Filters
- Two-stage dry air cleaner—centrifugal pre-cleaner with continuous dust ejector plus cleanable and replaceable dry filter element.
- Visual service indicator.
- Replaceable fuel filter/water separator element.
- Full-flow replaceable spin-on engine oil filter.
Electrical System
- Voltage: 12V
- Alternator: 63 amp
- Battery: 810 Cold Cranking amps at 0°F
Hydrostatic Drive
- 6,300 PSI (43,437 kPa) closed loop with piston pump and motors.
- 8 micron suction filter for charge pump.
- Self-contained, swashplate design, variable displacement, over center, piston pump.
- All pressure connections ORS and Code 62 O-ring flanges.
- Integral reservoir with implement hydraulics.
- Neutral start switch. (Park brake must also be engaged to start.)
- 2WD and 4WD inching.
- Electro/hydraulic traction lock valve for superior tractive effort.
Axles
- Planetary hubs with piston motors on rear axle.
- Piston motor-driven planetary front axle with high-bias limited slip differential.
Brakes
- Hydraulic wet disc brake on each front wheel.
- Hydraulic dynamic braking on front axle and both rear wheels.
Parking Brakes
- Wet disc spring-applied electro/hydraulic release.
- Light on dashboard indicates when brakes are on.
Tires
- Standard: 13:00 x 24 — 12PR, G2 type
- Optional: Radial 13:00 x 24 — 12PR G2 L2 rock tires
Cab
- ROPS/FOPS structure operator cab.
- Wrap-around dashboard with easy-to-read gauges.
Steering
- Hydraulic power steering with manual backup.
- Rear wheel steering, 90° pivot around either front tire.
- Outside turning radius is less than chassis length.
Instruments
- Volt meter, hourmeter, engine oil pressure, water temperature, fuel gauge.
- All gauges protected by clear acrylic cover.
Controls
- Grouped for operator comfort and convenience.
- Boom lift and crowd on single joystick.
- Left-hand tilt and sway lever.
- Foot throttle.
- Floor mounted traction lock switch.
- Optional: Single-lever tilt/sway control mounted on right-hand side of operator.
Hydraulic System-Implement
- Dual-section gear pump.
- Lift, crowd, tilt and sway cylinders have load checks to prevent dropping of load in the event of hose or other hydraulic failure.
Auxiliary Hydraulics
- Used for all attachments equipped with cylinders or other hydraulic components.
- Consists of valves, controls and hydraulic lines.
- Cab Enclosure
- Lockable, Dutch style door. Heater and defroster fan. Washer and windshield wiper.
- Heater & Defroster Fan
- Light Group
- 2 cab-mounted headlights, 1 backup/tail/stop light, rotating beacon.
- Cold Start Package
- Block heater and ether start.
- Radial and Rock Tires
- Suspension Seat
Standard Carriage
48 in. (1.2 m) or 72 in. (1.8 m)
Side Tilt Carriage
48 in. (1.2 m) or 72 in. (1.8 m)
100° Swing Carriage
72 in. (1.8 m)
Drywall Carriage
72 in. (1.8 m)
Pallet Forks
2 x 4 x 48 in. (51 mm x 102 mm x 1.2 m)
Cubing Forks
2 x 2 x 48 in. (51 mm x 51 mm x 1.2 m)
Truss Boom With or Without Winch
10 ft (3.0 m) or 15 ft (4.57 m) booms
Light Material Handling Bucket
0.75 cu yd (0.57 m 3) or 1.25 cu yd (0.95 m 3)
Vertical Mast
6 ft (1.8 m)
Swing Mast
6 ft (1.8 m)
Personnel Work Platform
Slip On Crane Hook
Interested in buying the JLG G6-42P? Contact MJ Equipment today!